Sold out

Tundra Magnuson 1900 Hub/Pulley Combo

$200.00
  • Tundra Magnuson 1900 Hub/Pulley Combo
  • Tundra Magnuson 1900 Hub/Pulley Combo
  • Tundra Magnuson 1900 Hub/Pulley Combo
  • Tundra Magnuson 1900 Hub/Pulley Combo

NOTE: IF YOUR PULLEY SIZE IS OUT OF STOCK CONTACT US AND THERE MAY BE COSMETIC BLEMISH OPTIONS AT A DISCOUNT - [email protected]

Select your pulley sizing based on the graphs shown. ~600 crank horsepower is generally assumed to be a "reliable" power level. Increase power at your own risk. SNIV SPEED SHOP IS NOT RESPONSIBLE FOR BLOWING UP YOUR ENGINE BECAUSE YOU RAN TOO SMALL OF A PULLEY!!!

RECOMMENDED SMALLEST PULLEY REQUIRES AT LEAST 650cc INJECTORS AND CUSTOM TUNING:

SEA LEVEL - 2000FT ELEVATION: 2.2

2000FT - 3500FT ELEVATION: 2.1

3500FT+ ELEVATION: 2.0

Don't forget larger injectors and tuning are needed for more boost! More details on pulley selection can be found here: https://www.snivspeedshop.com/pulley-sizing

I personally recommend running larger injectors with most pulley changes, however people have been known to run the 2.3 pulley at sea level with the Magnuson green 535cc injectors. Consult with your tuner.

Included in this combo:
1x Modular Hub
1x Pulley of your choice
12x 4-40 x 5/8" fasteners
1x Allen Wrench
1x Anti-Seize Packet

NOT Included:
-Way to remove or install modular hub

The hub is made from 300 series stainless steel, and the pulley is made from 7075-T6 aluminum. The hub is a press fit onto the TRD/Magnuson shaft, and allows the pulley to be swapped out in 15 minutes for a variety of sizes. The hub has a chamfered edge allowing for easy installation of the hub and belt in one motion instead of fighting to install the belt like a traditional pulley.

The pulley is held on with a redundant array of 12x 4-40 fasteners, meaning if you lose or break one, or even six fasteners, the pulley is not compromised. The pulley and hub have two integrated shear lugs that transfer torque between the belt and the supercharger, meaning the bolts only keep the pulley from falling off and allow for a superior and stronger load path than other options despite the small hub design.

The pulley is reversible and can be mounted on either face. The pulley and hub are corrosion resistant and arrive in a RAW form without coatings. Designed and machined in Utah.

Any questions email [email protected]